International Journal of Esthetic Dentistry  (English Edition)
Login:
username:

password:

Plattform:

Forgotten password?

Registration

Int J Esthet Dent 7 (2012), No. 4     10. Nov. 2012
Int J Esthet Dent 7 (2012), No. 4  (10.11.2012)

Page 418-429, PubMed:23150870


Identification of monoclinic phase in CAD/CAM zirconia FPD frameworks
Kypraiou, Villy / Pelekanos, Stavros / Eliades, George
Objective: The aim of this study was to identify the presence of monoclinic zirconia phase (m-ZrO2) in 5 computeraided design/computer-assisted manufacture zirconia systems composed of yttria-stabilized tetragonal zirconia polycrystals (Y-TZP).
Materials and methods: Three-unit fixedpartial dentures were prepared from Cercon (CR); Lava (LW); Zenotec Zr Bridge (WD); In-Ceram YZ (YZ); and IPS e-max ZirCAD (ZC), all milled in a pre-sintered stage and then fully sintered according to the manufacturers' instructions. Raman spectroscopy was used to identify and map the distribution of the m-ZrO2 phase at cervical crown margins, pontic and connector regions. Three sets of data were obtained from each material (n = 2) and the percentage volume (%Vm) of the m-ZrO2 phase was calculated per region. Statistical analysis was performed by two-way analysis of variance and Tukey test (a = 0.05).
Results: The m-ZrO2 phase was detected in all the specimens, with the highest intensity located at the crown margins. WD showed the lowest %Vm content (0- 3.14%), followed by LW (10.26-12.39%), CR (11.72-13.19%), ZC (11.13-14.10%) and YZ (12.15-14.99%). No statistically significant difference was found among LW, CR, ZC, YZ per region. Within each material group, significant differences were found between margin-pontic/connector (WD, YZ), margin-connector (CR, ZC) and margin-pontic (LW).
Significance: The Y-TZP destabilizing m-ZrO2 phase was identified in all the fully sintered frameworks tested, with the highest %Vm located at the margins. The extent to which the presence of this phase may be implicated with zirconia low temperature degradation or porcelain to zirconia bonding is unknown.
fulltext (no access granted) order article as PDF-file (20.00 €)